Clear the Slide
1.Lock the slide again and take away the journal. Examine the chamber to make sure it’s empty.
2.Utilizing a nylon brush, gently scrub the outside surfaces of the slide, taking note of any areas the place filth or particles has amassed. Keep away from utilizing harsh chemical compounds or abrasives that would injury the end.
3.**Barrel and Extractor Channel:**
|
Step 1: Take away the Barrel |
Step 2: Clear the Barrel |
|---|---|
|
a) Depress the locking block pin and pull the slide again barely to disengage the barrel. |
a) Run a patch soaked in cleansing solvent by way of the barrel from the chamber finish. Repeat till the patch comes out clear. b) Insert the barrel brush into the barrel and gently scrub the inside floor. Rotate the comb to make sure even cleansing. |
|
b) Elevate the barrel straight up and out of the slide. |
c) Dry the barrel completely utilizing a clear patch. |
|
Step 3: Clear the Extractor Channel a) Insert a cotton swab dipped in cleansing solvent into the extractor channel. Gently scrub the edges and backside of the channel. b) Dry the extractor channel completely utilizing a clear cotton swab. |
|
Clear the Body
1. **Take away the slide:** Push the slide launch lever upward on the left-hand aspect of the body, after which pull the slide ahead off the body.
-
Take away the barrel: Push the barrel lock lever upward on the left-hand aspect of the body, after which pull the barrel straight out of the body.
-
Take away the recoil spring meeting: Grasp the recoil spring meeting together with your fingers and pull it straight up out of the body.
-
Totally disassemble the recoil spring meeting: Disassembly of the recoil spring meeting varies barely relying on the technology of your Glock 19, however the normal steps are as follows:
- Pull the information rod out of the recoil spring.
- Separate the spring from the information rod and spring cap.
- On Gen 3 and Gen 4 fashions, take away the small "C-clip" from the highest of the information rod.
- Insert the information rod into the spring cap, then slide the spring over the information rod and snap the C-clip (if relevant) again into place.
Era Disassembly Notes Gen 3 Take away the small “C-clip” from the highest of the information rod. Gen 4 Take away the small “C-clip” from the highest of the information rod. Gen 5 No C-clip; merely insert the information rod into the spring cap and slide the spring over the information rod.
How To Clear A Glock 19
The Glock 19 is a well-liked semi-automatic pistol recognized for its reliability and sturdiness. Nevertheless, like several firearm, it requires common cleansing and upkeep to make sure correct operate and longevity. Cleansing a Glock 19 is a comparatively easy course of that may be accomplished with fundamental instruments and supplies.
To start, collect the required instruments and supplies. These embrace: a cleansing rod, a bore brush, a patch jag, cleansing patches, a lubricant, and a toothbrush. After getting every thing you want, observe these steps to wash your Glock 19:
1. Unload the pistol and take away the journal.
2. Lock the slide again.
3. Push the takedown levers down and take away the slide from the body.
4. Take away the barrel from the slide.
5. Clear the barrel with the bore brush and cleansing patches.
6. Clear the chamber with the chamber brush.
7. Clear the slide with the toothbrush and a fabric.
8. Clear the body with the toothbrush and a fabric.
9. Lubricate the pistol sparingly.
10. Reassemble the pistol.
