10 Easy Steps: How To Make A Gravity Bong With A Socket

Create the Chamber

1. Put together the bottle: Reduce the underside off the bottle, leaving a gap about 2-3 inches in diameter. This would be the chamber.

2. Make the socket gap: On the aspect of the bottle, about 2/3 of the way in which up from the underside, use a drill or sharp object to make a gap that’s barely bigger than the diameter of the socket.

3. Join the socket: Insert the socket into the outlet and seal it firmly with duct tape or sizzling glue. Be certain that the seal is hermetic to make sure a correct vacuum.

Seal the Bowl

Correctly sealing the bowl is essential to creating an efficient gravity bong. Comply with these steps to make sure a leak-proof seal:

Collect Mandatory Supplies

• Fantastic-grained grinding herb
• Small bowl piece
• Plastic socket
• Gaffer’s tape

Put together the Socket

• Create small holes within the backside of the socket utilizing a needle or sharp object.
• Insert the bowl piece into the socket, guaranteeing it suits snugly.
• Wrap gaffer’s tape across the base of the bowl and socket a number of occasions to create an hermetic seal.

Load the Herb

• Grind the herb finely utilizing a grinder or scissors.
• Pack the bottom herb into the bowl piece, urgent it down firmly.

Safe the Seal

• Place the socket-bowl meeting over the tip of the bottle or bucket.
• Press down firmly to create a good seal between the socket and the bottle.
• Verify for any leaks by barely lifting the socket. If there are leaks, tighten the seal with extra gaffer’s tape.

Extra Suggestions

• Use a clear socket to stop any odors or chemical substances from contaminating the smoke.
• Experiment with completely different bowl sizes and shapes to search out what works greatest for you.
• Change the gaffer’s tape often to make sure a correct seal.

Assemble the Lid

Now let’s assemble the lid. This can type the “head” of your gravity bong and can maintain the bowl in place.

1. Reduce a gap within the lid. Use a pointy knife to chop a gap within the lid that’s barely bigger than the bowl. The outlet must be centered on the lid.
2. Place the bowl within the gap. The bowl ought to match snugly into the outlet, in order that there is no such thing as a air leaks. If the outlet is simply too large, you need to use some tape or putty to seal it across the bowl.
3. Insert the stem into the lid. The stem is the a part of the gravity bong that connects the lid to the bottle. It must be lengthy sufficient to achieve from the outlet within the lid to only under the floor of the water within the bottle.
4. Seal the lid onto the bottle. Use a number of items of tape or some putty to seal the lid onto the bottle. Ensure that the seal is hermetic, in order that no air can leak out of the bottle.

Suggestions for Assembling the Lid

Listed below are a number of ideas for assembling the lid of your gravity bong:

Inhale the Smoke

Now that your gravity bong is assembled, it is time to inhale the smoke. Here is how:

1. Inhale by the mouthpiece, pulling the bottle up slowly.
2. Because the bottle rises, the smoke will fill the chamber.
3. Proceed inhaling till the bottle is totally the other way up.
4. Maintain the bottle the other way up for a second, permitting the smoke to chill barely.
5. Slowly exhale the smoke.
6. Repeat steps 1-5 to take one other hit.

Suggestions for Inhaling the Smoke:

Listed below are a number of ideas that will help you inhale the smoke from a gravity bong easily and successfully:

1. Inhale slowly and steadily.
2. Do not attempt to inhale an excessive amount of smoke directly.
3. Maintain the smoke in your lungs for a number of seconds earlier than exhaling.
4. In the event you begin to really feel lightheaded, cease inhaling and take a break.
5. Drink loads of water to remain hydrated.